PREORDER | Colibri II HPA Engine

Description

The Colibri II is the most cost-effective all-CNC HPA engine on the market. It's built with simplicity and cost reduction as priorities. It's made of high-strength polymers and aeronautic-grade aluminum to reduce weight and cost as much as possible without compromising on durability. Its internal mechanism is the same as the Colibri, but its body is full aluminum for better strength at a slight cost increase.

Main Features

• Single solenoid design for simplicity and reliability
• Open bolt: for the most cost effective desing possible
• Compatible with common gearbox types:
  • V2 (M4)
  • V3 (AK)
    
• Uses a MAC solenoid valve for fast cycling and efficient airflow
  
• Supports 30+ RPS (1800 RPM)
• Adjustable FPS through PSI and FCU settings
• Typical operating pressure:
  • 100–140 PSI
• Very low maintenance due to minimal moving parts

Efficency

• 1000+ shots from 13/3000
• 1.5J (120PSI w/ .28g) 
• 365mm barrel lenght

Recommandations

• Best used with 0.32g bb or higher.
• we recommande using the:
  •  MadBull Red 60 Degree Shark Bucking
  • GnG Green Bucking

FCU (Fire controle unit)

The FCU can :

• Cycle trough multiple rmp:
  • While in single fire, hold the trigger for 1.5 to 3 seconds to cycle trough 3 preprogram RPMs.
• Change fire mode to binary:
  • While in single fire, hold the trigger for more then 6 seconds to change from sigle to binary.
• Be programed by usb to with custom FCU programmer:
  • change the rpm as you please.
  • change valve open time for better efficency.
• Be used with 3s (11.1v) and 2s (7.4v) lipo battery:
  • The battery is not included.